Specifications

Gas Conversion

5. Insert 1/2² deep-well socket with extension through the

opening in the bake chamber from which the burner

was removed. Insert tool at a downward angle to the

left till it seats over the hex on the bake orifice.

Turn socket counter-clockwise until orifice is loose,

remove orifice and tool through opening in bake

chamber.

klqbW The bake orifice can also be viewed under the

range by raising the oven door and removing the

storage drawer. See figure 4.

6. Locate LP bake burner orifice in LP conversion kit

plastic bag mounted at rear of range. Orifice will be

marked “.049”.

7. Install LP orifice in same 1/2² socket and attach to bake

burner valve by repeating procedure noted in step #5

above. Turn socket clockwise until resistance is felt,

then another 1/4 turn to fully tighten.

8. Before re-installing oven bottom, refer to the section

titled “Range Adjustments” in the unit installation

manual for proper air shutter adjustment on bake

burner.

9. Reverse steps 1 - 4 above to complete the conversion.

fjmloq^kqW Be sure end of burner is engaged over

burner orifice.

cfdrob Q

VIEWING THE BAKE ORIFICE AFTER

THE REMOVAL OF THE STORAGE DRAWER

BAKE ORIFICE

LP BAKE ORIFICE IS

LOCATEDINTHELP

CONVERSION KIT AND

IS STAMPED WITH

NUMBERS “.049”.