Specifications
A – 2 16022498 ©2003 Maytag Appliances Company
Gas Conversion
*DV &RQYHUVLRQ
d~
This range is equipped with fixed orifices on all burners
and a convertible appliance pressure regulator. The unit
serial plate states which gas it was adjusted for at the
factory. To convert the unit to either Natural gas or LP gas
will require replacing the oven orifice hoods, replacement
of top burner orifices, conversion of the appliance
pressure regulator and adjustment of air shutters on both
oven burners.
Gas inlet pressure to the appliance pressure regulator
should be as follows for both operation and checking of
appliance pressure regulator setting:
fkibq mobpprob fk k^qro^i im
fk`ebp lc t^qbo `lirjk
d^p d^p
Minimum 5 11
Maximum 14 14
^~ m o~ `
The unit appliance pressure regulator must be set to
match the type gas supply used. If converting from
Natural gas to LP gas, the appliance pressure regulator
must be converted to regulate LP gas. If converting from
LP gas to Natural gas, the appliance pressure regulator
must be converted to regulate Natural gas. The regulator
is located at the bottom of the back of the range.
Follow the instructions below to convert the regulator for
use with LP gas. (This appliance is shipped from the
factory adjusted for use with Natural gas.)
1. Remove plastic cover from pressure regulator neck.
Seefigure1.
3/$67,& &29(5
),*85(
*$6 35(6685( 5(*8/$725
/2&$7(' $7 %27720 2) 7+( 5($5 2) 7+( 5$1*(
2. Unscrew the hex shaped conversion cap from the neck
of the regulator. (A wrench may be required to loosen
the cap). See figure 2.
),*85(
1$785$/ *$6 6(77,1*
´1µ ,6 6+2:1
7851 ,1 &2817(5&/2&.:,6(
',5(&7,21 72 5(029(
3. Invert the cap and screw it back into place. See figure
3.
),*85(
/3 *$6
6(77,1*
´/3µ ,6 6+2:1
4. Screw the cap securely back into place in the neck of
the pressure regulator. (The cap need not be wrench-
tightened upon replacement. Firm finger tightening will
secure the cap). Replace plastic cover over cap. See
figure 4.
),*85(
7851 &/2&.:,6(
72 ,167$//
UNMNmRVUJSM
(07-03-00)