Instruction Sheet for Fascia Heater and 1 Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shook, Unplug refrigerator or disconnect power. Open both refrigerator compartment doors. Remove all terns from top shelves and remove shelves. See Figure 1. .
10. To remove the Walter reservoir cover, slide it completely 13. Disconnect ice maker fill ube from water valve. forward and disconnect LED lighting connection. Place side. See Figure 8 14. Locate the two 14 screws attaching the foe box assembly and remove using % nut driver. Side ice box assembly forward to remove. See Figure 71. 18. Remove the adapter from the ice box assertively. Use Flathead .
18. Remove foil fill tube heater from the ice maker fill tubs on the ice box and discard, See Figure 14. If your ice box assembly had a revised ice box fascia with fascia heater, you will need to remove the wires and grommet from the ice box cover. ICEBOX | COVER NOTE: Skip ahead to step 23 if your ice box assembly had a revised ice box cover with through hole (fascia heater and grommet), See Figure 15.
27. Peel paper backing half-way off new gasket. Position gasket fo touch bottom of air ducts with adhesive side on the liner. See Figure 21. Apply gasket to back wall of liner. FIGURE 2 28. Peel remainder of paper backing off new gasket after positioning behind top of tower. See Figure 22. ET FIGURE 22 28. Position ice box assembly over air ducts on the rear wall of the cabinet while engaging the hooks on top of the assembly FIGURE 13 30.
Supplemental Wiring Sheet (Insert) {Place this page with current tech sheet) {IMPORTANT: The changes below represent the installation of a Service Fascia Heater kit. This supplemental wiring sheet should be left with the origins! tech sheet provided with refrigerator, back under the top right hinge cap.
