Installation guide

LEVEL WASHER]DRYER
iMPORTANT: Level washer/dryer properly to reduce excess
noise and vibration.
fl, Check levelness of washer/dryer
- -- _ _ i
. o
With washer/dryer in its final location, place a level on top
edges of washer/dryer. Use side seam as a guide to check
levelness of sides. Check levelness of front using lid, as
shown. Rock washer/dryer back and forth to make sure all
four feet make solid contact with floor. If washer/dryer is level,
skip to step 2.
Not Level LEVEL Not Level
Adjust leveling feet
If washer/dryer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer/dryer cabinet. Then
turn the leveling foot clockwise to lower the washer/dryer or
counterclockwise to raise the washer/dryer. Recheck levelness
of washer/dryer and repeat as needed.
HELPFUL TiP: You may want to prop up front of washer/dryer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer/dryer.
Tighten leveling feet
When washer/dryer is level, use a 9/16" or 14 mm open-end
or adjustable wrench to turn jam nuts counterclockwise on
leveling feet tightly against washer/dryer cabinet.
HELPFUL TiP: You may want to prop washer/dryer with
a wooden block.
in U.S.A.
Electrical Shock Hazard
Plug into a grounded 3 or 4 prong outlet,
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
f4., Plug into a grounded 3= or 4= prong
outlet
23