Installation guide

CONNECT INLET HOSES

Check for leaks

Turn on water faucets to check for leaks. A small amount of

water may enter washer. It will drain later.

Secure drain hose

Standpipe Wall

4.5"

(114 ram)

Secure drain hose to laundry tub leg, drain standpipe, or inlet

hoses for wall standpipe with shipping strap removed earlier.

CONNECT VENT

1, Connect vent to exhaust outlet

Connecting from front Connecting

(for closet or recessed from rear

area)

Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure vent is

clean. Dryer vent must fit over dryer exhaust outlet and inside

exhaust hood. Check that vent is secured to exhaust hood

with a 4" (102 mm) clamp.

f2, Move washer/dryer to final location

Move washer/dryer to final location, taking care not to crush

or kink vent.

After washer/dryer is in place, remove corner posts and

cardboard from under washer/dryer.