Installation guide

Notice To Installer
Follow accompanying instruction carefully.
Never use a meta I blade to pry knob off
cannot be easi!y removed; tuck folds 0f a
dishtowel under knob skir t and pull upward with
steady, even pressure.
Preparation Of Countertop
The cutout in the countertop into which the appliance is to
be installed should be prepared according to the cutout
dimensions given on page 1 of these instructions.
CAUTION
dimensions are critical, Dimensionsl
must be measured and cu t accurately t° within
+!!!6 (;!6 cm) to insure proper fit;
Installation Of Appliance
1. Remove the cooktop from the carton and place it
upside down over two soft pads making sure control
knobs do not interfere with any surface.
2. Provide cutout in countertop as required per page 1.
3. Place unit in the cutout.
4. Make electrical wire connection to unit. Consult local
codes for proper power hook-up.
5. Test to insure control knobs operate all elements
properly.