User`s guide

ManualsBrandsMaytag ManualsDishwasherMDB8959SBB1

LEAVE INSTALLATION INSTRUCTIONS AND

USER'S GUIDE WITH OWNER

PLEASE READ COMPLETE INSTRUCTIONS BEFORE YOU BEGIN

BUILT-IN DISHWASHER

INSTALLATION INSTRUCTIONS

BUILT-IN DISHWASHER

INSTALLATION INSTRUCTIONS

ALL ELECTRIC WIRING AND PLUMBING MUST BE DONE

IN ACCORDANCE WITH NATIONAL AND LOCAL CODES.

PRINTED IN USA

6 915126 B

Summary of content (6 pages)

PAGE 1
BUILT-IN DISHWASHER INSTALLATION INSTRUCTIONS PLEASE READ COMPLETE INSTRUCTIONS BEFORE YOU BEGIN LEAVE INSTALLATION INSTRUCTIONS AND USER'S GUIDE WITH OWNER ALL ELECTRIC WIRING AND PLUMBING MUST BE DONE IN ACCORDANCE WITH NATIONAL AND LOCAL CODES.
PAGE 2
rt Here Sta TOOLS NECESSARY FOR INSTALLATION SUPPORT ACCESSORIES: CUTTING KNIFE RATCHET 3/16", 1/4", 5/16" SOCKETS PHILLIPS SCREWDRIVER STANDARD SCREWDRIVER WIRE CUTTERS CRESCENT WRENCH ADJUSTABLE PLIERS LEVEL 3/4" UL Approved Strain Relief (provided) 2 Appropriate Sized Wire Nuts 3/8" Male (N.P.T.
PAGE 3
WATER VALVE PREPARATION Remove shipping plug from water inlet valve. Water Valve Install a 90° elbow (3/8" N.P.T) fitting into the water valve using Teflon™ tape or pipe thread compound. The opposite end of the fitting should fit in-coming hot water supply line. Position the end of the elbow towards the rear of the dishwasher. IMPORTANT: DO NOT connect a sweat type fitting directly to the water valve as the required heat will damage the water inlet valve. Do not solder within 6" (15.
PAGE 4
POSITIONING THE DISHWASHER (continued) Tip: Check to be sure there is no interference with water line and wiring. Verify that power is turned off at source. Tip: When installing dishwasher near a corner, allow enough room for the door to open without interferring with any cabinets, drawers, or hardware. LEVEL DISHWASHER Leveling legs align the dishwasher vertically and horizontally.
PAGE 5
MAKING THE ELECTRICAL CONNECTIONS SEE THE ELECTRICAL REQUIREMENTS SECTION CAUTION: Verif y power to dishwasher is off at source. Remove terminal box cover. In order to secure the power supply cable, a UL listed strain relief must be used to secure the power supply to the back of terminal box. Strip approximately 3/8" (.09 cm) of insulation from incoming power supply wires. Connect these wires to wires from dishwasher wire harness located in the terminal box.
PAGE 6
CAUTION: Disconnect electrical power before you start! ALL ELECTRICAL WIRING AND GROUNDING SHOULD BE DONE IN ACCORDANCE WITH NATIONAL AND LOCAL CODES. CAUTION: To prevent accidental contact with electrical connections, built-in dishwasher models must not be connected to a power source unless the dishwasher is completely enclosed, with front panels in place. If the back or either side of the dishwasher is exposed, a custom-made panel must be used to complete this enclosure.