Installation manual

OPERATINGrips
CLEAN IT
, Aftereach load.
• To shorten drying time.
• To operate more efficiently.
NOTE:
Do not operate the dryer
without the lintfilter in place.
LOADTHEDRYERPROPERLY
By placing only one wash load in the
dryer at a time.
Avoid very small loads or mixing
heavyweight and lightweight clothes.
When only one or two articles need
drying, add a few similar items to
improvetumbling and drying efficiency.
When drying large, bulky items such
as a blanket or comforter, it may be
necessaryto repositionthe load during
the cycle to ensure even drying.
ADDAFABRICSOFTENER
SHEET(iFD str D)
• After loadingthe dryer,
• To control static cling,
• Before the load becomes warm.
This helps prevent greasy-looking
softener stains.
• And remove any used softener
sheets from the dryer to prevent
greasy-looking softener stains.
CHECKTHEMOISTURE
MOF!ITOR
Indicator lights in the moisture monitorwill
displaywhen an IntelliDry cycle is in oper-
ation.The top light will blink on and off.As
loads dry, there will be longer pauses
between each blink. No lights will display
during Time Dry or Air Fluff.
The bottom light in the monitor will remain
on until the cool down portion of the cycle
starts. During cool down the dryer contin-
ues to tumble the load in unheated air to
help minimize wrinkling.
MOISTURE MONITOR
MORE
LESS
NOTE: The top monitor light
may not blink when small loads
of heavy, bulky items are dried,
such as rugs or sweaters.
4