® DB10 Bottom Freezer Refrigerator Trim Kit Installation Instructions Keep these instructions for future reference. If the refrigerator changes ownership, be sure this manual accompanies refrigerator.
Contents Decorator Panel Dimensions Introduction ................................................................ 2 Parts list .................................................................... 2 Decorator Panel Dimensions ...................................... 2 Procedure .................................................................. 3 Listed below are required height x width dimensions for decorator panels. Panels are not supplied with this kit and can be purchased locally.
Procedure 13. Install freezer door by positioning door on bottom hinge pin. 14. Install center hinge pin and door closure. 15. Install freezer door decorator panel by sliding panel in from handle side of freezer door. 16. Align handle side freezer door trim. After verifying placement, peel off paper backing and press trim in place. Handle side freezer trim will be cupped on both ends. 17. Open door 180° then close door to confirm panel and trim fit properly.
23. Align handle side door trim. After verifying placement, peel off paper backing and press trim in place. Handle side trim will have 4 holes for screws to mount the handle, and cupped on both ends. Refrigerator door Top trim Handle Side trim 29. Open door 180° then close door to confirm panel and trim fit properly. 30. Replace handles by positioning handles on door. Insert and tighten screws with a Phillips screwdriver. 31. Replace screw caps on refrigerator and freezer handles by snapping on. Part No.
