Technical information

Service Specifications

16026747 April 2006

WARNING

To avoid the risk of electrical shock, personal injury, or death, disconnect power to unit before servicing, unless

testing requires power.

CONSOLE SWITCH TEST CON’T

Press the Cycle Selection Knob. The test continues with

the switch immediately to the left of the previous switch

tested. Repeat rotating the switch and monitoring the

LED’s around the bottom of the Cycle Selection Knob.

Continue pressing the Cycle Selection Knob for each

switch tested right to left until all rotary switches are

tested.

NOTE: The Water Level Switch is not included in this

test.

• After the last rotary switch is tested the next time the

Cycle Selection Knob is pressed the test will continue

with the rocker switches. Continue pressing the

Cycle Selection Knob and testing switches until the

last switch is tested. When all switches have been

tested the “Complete” LED will illuminate.

SERVICE CYCLE

Enter ‘Service Mode’ then set Cycle Selection Knob to “Regular” and

press knob.

• “Fill” and “Wash” LED’s illuminate. Hot water fill

• Press knob, “Fill” and “Rinse” LED’s illuminate. Cold water fill

• Press knob, “Fill”, “Wash”, and “Rinse” LED’s illuminate.

Selected wash temperature fill.

• Press knob, “Wash” LED illuminates. Slow agitation

• Press knob, “Wash” LED blinking. Fast agitation

• Press knob, “Spin” LED illuminates. Slow spin

• Press knob, “Spin” LED blinking. Fast spin

• Press knob, “Complete” LED illuminates.

• Press knob, exit back to ‘Service Mode’.

NOTE: Fills are skipped if Pressure Switch is satisfied. Press knob

until “Pause” LED begins blinking to pause cycle