Technical information

Service Specifications
April 2006 16026747
©2006 Maytag Services
5
!
WARNING
To avoid the risk of electrical shock, personal injury, or death, disconnect power to unit before servicing, unless
testing requires power.
DISPLAY/CLEAR SERVICE CODES
Enter ‘Service Mode’ then set Cycle Selection Knob to
“Rinse & Spin”. Press knob.
• “Rinse & Spin” LED will blink if codes other than
power interrupt are present.
• Press knob to view codes. Press once for each
code. Codes are displayed newest to oldest.
Machine beeps three times after last service code is
displayed.
• Refer to ‘DIAGNOSTIC CODE CHART’ for Service
Codes.
• To clear codes display a code then press and hold
Cycle Selection Knob until machine beeps twice.
“Rinse & Spin” LED will stop blinking.
CONSOLE SWITCH TEST
Enter ‘Service Mode’ then set Cycle Selection Knob to
“Delicate” and press knob.
• “Power Off” LED blinks.
• “Pause” and “Delicates” LED’s are illuminated.
Rotate the Cycle Selection Knob clockwise for ascending, and
counterclockwise for descending test mode. Rotate 32 clicks
in the same direction to complete the test.
Press the Cycle Selection Knob to activate the test for the
rotary switches. The test begins with the rotary switch
immediately to the left of the Cycle Selection Knob. Rotate the
switch in either direction. The LED’s illuminate around the
bottom of the Cycle Selection Knob for each switch position.
NOTE: Any attempt to move a knob or switch other than the
one being tested results in a chirp sound.