Specifications

Product Dimensions
A. 109 cm (43") I. Power supply cord
B. 97 cm (38%") J. Drain hose connector
C. 89 cm (35") K. Label
D. 3.8 cm (11½") L. 68.5 cm (27")
E. 70.5 cm (273/4'') M. 13.3 cm (51/4'')
R 65cm(251½ '') N. 2.5cm(1")
G. Water inlets O. Water level switch and shaft
H. 18 cm (7") R 12.7 cm (5")
Standpipe Drain System
The standpipe drain requires a minimum diameter standpipe of
5 cm (2"). The minimum carry-away capacity can be no less than
64 L (17 gal.) per minute.
The top of the standpipe must be at least 99cm (39") high and
no higher than 183 cm (72") from the bottom of the washer.
Electric Shock Hazard
Electrically earth this appliance.
Do not use an extension cord or an electrical portable
outlet device.
Failure to follow these instructions can result in death,
fire, or electric shock.
[] A 220-240 volt, 50 Hz., AC only, 10-amp, fused electric
supply is required. A time-delay fuse or circuit breaker is
recommended. It is recommended that a separate circuit
serving only this appliance be provided.
[] This washer is equipped with a power supply cord having
an earthing plug. The plug should be accessible for
disconnection from the supply.
[] If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent, or similarly qualified
persons in order to avoid a hazard.
Using the universal cord included with this washer:
This washer is equipped with a universal cord with
interchangeable mains plugs.
1. Select the appropriate mains plug assembly from those
supplied and attach it to the mains cord connector.
2. Snap the 2 halves of the cord lock together over the
connector to retain it in position.
5