Technical information

Component Testing Procedures
!
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless
testing requires power.
December 2003 16022843 Rev 0
17
Display flashes in
user Mode
Check for proper
adjustment of
vault switch
Check wiring and
terminations between
vault switch and control
board
Unplug washer and connector CC
and FF. Check for continuity
between yellow/black wire on
connector CC and orange wire on
connector FF while cycling vault
switch
Does vault switch
open and close
properly?
Replace control
board
Replace vault
switch
NoYes
Water runs
without program
selected
Unplug washer.
Does water still
run?
Check wiring and
terminations between
control board and water
valve
If problem still
exists replace
control board
Replace water
valve
No
Yes
Run washer
diagnostics
program
No hot water or
cold water
Run washer
diagnostics
program
Spin instead of
agitating
Run washer
diagnostics
program
No spin or
agitate