Technical information

Troubleshooting Procedures
!
WARNING
To avoid risk of electrical shock, personal injury, or death; disconnect power to washer before servicing, unless
testing requires power.
16027174 June 2006
RPL 16023431
©2006 Maytag Services
8
list, the display will remain at the top or the end of the
list. A pair of dashes “
- -” will be displayed at the end
of the list of diagnostic codes. If the user navigates up
the list of codes, when the control reaches the top, it will
again show “d”.
A code generated during the current cycle will be
displayed with the Spin Indicator LED turned ‘ON’. If no
cycle is currently running, a code generated during the
previous cycle will be displayed with the Spin Indicator
LED turned ‘ON’.
Access Other Features
While a diagnostic code is displayed, if the Start Pause
button on the rotary cycle selector knob is pressed and
held, the machine will display the number of cycles
since the diagnostic code occurred. To clear the
diagnostic list, press the Delay Start and Soil Level
keys for 3 seconds while viewing the list.
Diagnostic Codes
Diag.
Code
Description Trigger Action to be
taken
1 No Drain
The water
level fails to
drop below
the Low
Water level
reset within
15 minutes,
before a spin
begins.
Displays "nd"
Go to "Will Not
Drain"
Troubleshooting
Section
2
Not Used
3 No Fill
Continuous fill
of 12 minutes.
Total fill of 20
minutes.
Displays "nF"
Go to "No Water
Fill".
4-7
Not Used
8
Water level
sensor fault.
Input signal
from water
level Sensor
is out of
range,
Washer will
beep and
pause the
wash cycle.
Displays "LE"
Go to “No Water
Fill”.
Diag.
Code
Description Trigger Action to be
taken
9 Not Used
10
Unbalance
detected
during final
spin, which
prevented
the spinner
from
exceeding
400 rpm.
Never
exceeded 400
rpm due to an
unbalanced
load. If
detected,
washer will
pause and
alert user to
redistribute
the load.
LED – Will display
“dc”
Go to "Machine
Control Board
Output Test".
11
Will not
remember
machine
settings.
Difficulty in
reading
memory.
Go to "Clear
diagnostic codes"
Disconnect and
reconnect the
washer power cord
at power supply
outlet.
If condition still
exists, replace
machine control
board.
12-17 Not Used
18
Detected
door lock
switch open
during cycle
when not
expected.
Open door
lock switch
with motor
running.
Check for loose
wire connections
Clear the diagnostic
code and recheck;
if reoccurs, perform
Diagnostic
Motor/Machine
Control Board test
Check for faulty
motor relay on the
machine control
board.