Manual

Won't Filt
Won't Agitate
* Plug cord into live electrical outlet.
* Check fuse or reset circuit breaker.
* Close lid and pull control knob out to start the washer. For your safety,
washer will not fill unless the lid is closed.
* Turn both faucets on fully.
* Straighten inlet hoses.
, Disconnect hoses and clean screens. Hose filter screens may be plugged.
* Check _ase or reset circuit breaker.
* Turn the control knob to proper cycle and pull knob out to start the washer.
* Close lid and pull control knob out to start the washer. For your safety,
washer will not agitate or spin unless the lid is closed.
* Unevenly distributed load. Redistribute the load, close the lid and pull knob
out. Check for leveling. Be sure water level is acceptable for load size.
* Check fuse or reset circuit breaker.
* Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction,
call for service.
* Close lid and pull control knob out to start the washer. For your safety, wash-
er will not agitate or spin unless the lid is closed.
* Suds lock - caused by too much suds. Rewash without detergent. Use cor-
rect amount of a low-sudsing detergent.
(Continued on next page.)
11