Installation guide

240 EdwardsStreet,SE
C!eveland,Tenressee37311
TeJ:423-472-3333
Fax:[phone]!0
ALCOVE OR CLOSET INSTALLATION
When the stacked washer/dryer is to be installed in an alcove area or a closet, clearance
should be provided around the unit for an adequate air supply and for ease of installation and
servicing. An appliance installed in a closet shall have no other fuel burning appliance
installed in the same closet, such as gas furnace, water heater or space heater, etc.
The dryer must be exhausted to the outside to minimize excessive lint accumulation and to
maintain good drying. We recommend allowance for more clearance than the minimum
installation clearances as shown.
\
36 Sq. I
Openin_
J
Each opening area must have a minimum of 36 square inches. These openings must not be
obstructed. (Louvered door with equivalent air opening is acceptable).
MOBILE HOME INSTALLATION
Installation of Maytag dryers certified by the American Gas Association and bearing a label
stating they are suitable for installation in mobile homes, when installed in mobile homes,
must conform to the Manufactured Home Construction and Safety Standard Title 24 CFR,
part 32-80.
When installing a dryer in a mobile home, provisions for anchoring the dryer should be
made. An anchor bracket kit is available, Part No, 303740 to fasten dryer stand to floor.
Instructions for installing the anchor brackets are contained in each kit.
All mobile home installations must be exhausted to the outside with the exhaust duct termi-
nation securely fastened to the mobile home structure, using materials that will not support
combustion. Exhaust the dryer using flexible metal exhausting materials and locate in an area
that provides adequate make-up air. The exhaust duct may not terminate beneath the mobile
home.
:S