User guide

-: C_s_omerS{r_ice ,A_I]_
240EdwardsStreet,SE
Cleveland,Tennessee37311
TeL[phone]
Fax:[phone]G
4-WIRE SYSTEM CONNECTIONS
Remove the ground strap screw from the terminal block support. Fold the ground strap over
so both ends of the ground strap are attached to the center terminal block post.
Connect the neutral white conductor of the cord to the center (silver) colored post of the
terminal block. Connect the grounding (green) wire of the cord to the terminal block support
using the ground strap screw.
Connect the red and black wires of the cord to the outer posts of the terminal block.
Be sure the terminal block nuts are tight. Secure the power cord in position. Tighten the
strain relief screw(s) in order to clamp the strain relief to the cord.
Replace the terminal block cover.
WARNING: If converting from &wire electrical systems to 3-wire, the ground strap must
be reconnected to terminal block support to ground the dryer frame to the neutral insulator.