Specifications

WARNI NG
!
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
Microwave Disassembly Procedures
©2004 Maytag Appliances Company 16022821 Rev. 0 33
Touch Panel
NOTE: Requires removal of unit from cabinet.
1. Turn off power to the unit at the circuit breaker.
2. Open oven door and microwave door to remove screws
securing trim of unit to the cabinet opening.
NOTE: Place a protective covering on the floor, to avoid
damage to the floor.
CAUTION
!
To avoid risk of property damage and personal injury,
place blocking material underneath the front edge of
the wall oven to prevent unit from tipping forward.
3. Slide unit out of cutout.
4. Remove screws securing top wrapper to chassis and
remove top cover.
5. Disconnect terminal plug from control panel.
CAUTION
!
While unplugging electrical connections, pins may be
damaged, use extreme care when disconnecting.
6. Slide control board holder to the left to release from
control panel.
7. Reverse procedure to reassemble.
Control Power Board
NOTE: Requires removal of unit from cabinet.
1. Turn off power to the unit at the circuit breaker.
2. Open oven door and microwave door to remove screws
securing trim of unit to the cabinet opening.
NOTE: Place a protective covering on the floor, to avoid
damage to the floor.
CAUTION
!
To avoid risk of property damage and personal injury,
place blocking material underneath the front edge of
the wall oven to prevent unit from tipping forward.
3. Slide unit out of cutout.
4. Remove screws securing top wrapper to chassis and
remove top cover.
5. Label and disconnect wire terminals from control
power board.
CAUTION
!
While unplugging electrical connections, pins may be
damaged, use extreme care when disconnecting.
6. Remove screws securing transformer to power control
board bracket.
7. Reverse procedure to reassemble.
Filter Assembly Board
NOTE: Requires removal of unit from cabinet.
1. Turn off power to the unit at the circuit breaker.
2. Open oven door and microwave door to remove screws
securing trim of unit to the cabinet opening.
NOTE: Place a protective covering on the floor, to avoid
damage to the floor.
CAUTION
!
To avoid risk of property damage and personal injury,
place blocking material underneath the front edge of
the wall oven to prevent unit from tipping forward.
3. Slide unit out of cutout.
4. Remove screws securing top wrapper to chassis and
remove top cover.
5. Label and disconnect wire terminals from filter
assembly board.
6. Remove screws securing filter assembly board to
blower bracket.
7. Reverse procedure to reassemble.