Use & care guide
Drainhosemustbesecuredtostopthehosefrommovingwhen
is.p out.
water umped Ifthedrainhosemoves,watermayendupon
thefloor
1. Drapethepowercordoverthewashertop.
2. Movethewashertoitsfinallocation.
3. Placethedrainhoseinthelaundrytuborstandpipeasshown.
SeeillustrationsAandB.
NOTES:
• Donotforceexcessdrainhosebackintotherearofthewasher.
1 II
• To avoid siphoning, do not sea[ or put more than 4/_
(114 mm) of the drain hose into drainpipe or standpipe.
4. If the washer faucets and the drain standpipe are recessed, put
the hooked end of the drain hose in the standpipe as shown. See
illustration C.
Proper foot to floor contact and leveling your washer avoids
excessive noise and vibration.
NOTE: Installing washer on soft floor surfaces, such as carpets or
surfaces with foam backing, is not recommended.
1. Slide the washer to its final location.
2. Check that a[[ four feet are in firm contact with the floor.
3. Check the levelness of the washer by placing a [eve[ on the top
edge of the washeb first side to side then front to back.
5. After the washer is [eve[, and a[[ four feet are in firm contact with
the f[oob use a 9/1 6" (14 mm) open-end wrench to turn the
[ocknuts on the feet, tightly against the washer cabinet.
IMPORTANT: A[[ four [ocknuts on the feet must be tightened. If
the [ocknuts are not tight against the washer cabinet, the washer
may vibrate.
6. The washer should not move front to back, side to side, or
diagonally when pushed on its top edges.
7. Confirm the levelness of the washer.
i
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See "Electrical Requirements."
2. Check that a[[ parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have a[[ of your tools.
4. Dispose of/recycle a[[ packaging materials.
5. Check that both water faucets are on.
6. Check for leaks around faucets and inlet hoses.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7.
8.
9.
Plug into a grounded 3 prong outlet.
Read "Washer Use."
To test and to clean your washeb measure 1/2 the detergent
manufacturer's recommended amount of High Efficiencv (HE)
detergent for a medium-size load. Pour the detergent into the
detergent dispenser. Select NORMAl_ and then press START/
PAUSE. Allow the washer to complete one whole cycle.
4.
If the washer is against a wail, move the washer out slightly
before tipping back. If the washer is not level, first prop the front
with a wooden block and adjust the front feet height moving the
hexagonal plastic part as necessary. Repeat to adjust back feet.
Make sure all four feet are in firm contact with the floor. Then
check that the washer is perfectly level (use a level). Repeat steps
1-3 until washer is level.
Use only HI High Efficiency detergent.
10