Specifications

2-1
INSTALLATION INFORMATION
INSTALLATION INSTRUCTIONS
TOOLS AND PARTS
Gather the required tools and parts before
starting installation. Read and follow the safe-
ty instructions provided with any tools listed
here.
Electric Models
Flat-blade screwdriver•
#2 Phillips screwdriver•
Adjustable wrench that opens to 1• ˝ (2.5 cm)
or hex-head socket wrench (for adjusting
dryer feet)
Wire stripper (direct wire installations)•
Level•
Vent clamps•
Caulking gun and compound (for installing •
new exhaust vent)
Tin snips (new vent installations)•
1/4• ˝ nut driver or socket wrench
(recommended)
Tape measure•
Gas Models
8• ˝ or 10˝ pipe wrench
8• ˝ or 10˝ adjustable wrench (for gas
connections)
Flat-blade screwdriver•
Adjustable wrench that opens to 1• ˝
(2.5 cm) or hex-head socket wrench (for
adjusting dryer feet)
1/4• ˝ nut driver or socket wrench
(recommended)
Level•
Vent clamps•
Knife•
Pipe-joint compound resistant to LP gas•
Caulking gun and compound (for installing •
new exhaust vent)
Pliers•
Tape measure•
NOTE: Do not use leveling legs if installing
the dryer on a pedestal.
Parts needed
Check local codes and with gas supplier.
Check existing gas supply, electrical supply
and venting. Read “Electrical Requirements,”
“Gas Supply Requirements” and “Venting Re-
quirements” before purchasing parts.
For close-clearance installations between •
28.65˝ (72.77 cm) and 34.15˝ (86.74 cm),
see “Plan Vent System” section for venting
requirements.
4 Leveling legs
Parts Supplied
Remove parts packages from dryer drum.
Check that all parts are included.
Parts package•
Mobile home installations require special
parts (listed following) that may be ordered by
calling the dealer from whom you purchased
your dryer. For further information, please re-
fer to the “Assistance or Service” section of
the “Use & Care Guide.”
Mobile Home Installation Kit. Ask for Part •
Number 346764.
Metal exhaust system hardware.•
34.15"
(86.74 cm)