Specifications

6-16
ACCESSING THE MACHINE
CONTROL ELECTRONICS
1. After locating the machine control electron-
ics, remove the two screws that hold the
machine control electronics bracket in place.
2. Slide the bracket over the top of the drum
to access the machine control electronics
connectors and mounting screw. See Fig-
ure 16.
REMOVING THE MACHINE
CONTROL ELECTRONICS
1. Remove all the wire connections to the ma-
chine control electronics. See Figure 17.
2. Remove the screw holding the machine
control electronics assembly to the mount-
ing bracket. See Figure 16.
3. There are two plastic legs on the front of
the machine control electronics that slide
under the mounting bracket. There is one
plastic leg on the rear of the machine control
electronics that slides under the mounting
bracket. There is a locking tab on the
bottom of the machine control electronics
that snaps into the mounting bracket.
Press the locking tab on the bottom of the
machine control electronics and slide the
assembly to the front, then lift.
FRONT
Machine Control
Electronics
Bracket
Machine Control
Electronics
Assembly
Mounting
Screw
Figure 16. Remove machine control
electronics from mounting bracket.
P9
1
5
1
P8
P14
P2
3
1
1
6
P4
1
1
8
3
P5
P3
1
P13
1
X veR XXXXXX N/P
xx-DDDYedoC etaD
XXX-XXXX
OOC NI EDAM
N.O.
Black
COM
Red
Heater
Relay 1
Motor
Relay
Tan
Black-White
White
Green-Yellow
Open
Lt. Blue Black
Heater Relay 2
Red-White
Open
Red-White
Yellow-Red
Orange (Gas)
Open (Elec.)
Figure 17. Machine control electronics.