Specifications

6-7
10. If both visual checks pass, replace the
console electronics, housing assembly,
and all parts and panels before operating.
11. Plug in dryer or reconnect power.
12. Perform the Console Buttons and Indicators
Diagnostic test to verify repair.
13. If indicators still do not light, the machine
control electronics has failed:
Unplug dryer or disconnect power.•
Replace the machine control electronics.•
Replace all parts and panels before •
operating.
Plug in dryer or reconnect power.•
Perform the Console Buttons and Indi-•
cators Diagnostic test to verify repair.
GAS DRYER
1. Unplug dryer or disconnect power.
2. Remove the cover plate from the top right
corner of the back of the dryer. See Figure 3.
3.Check that the power cord is rmly
connected to the dryer’s wire harness. See
Figure 5.
Power Cord
Wire
Harness
Figure 5. Power cord-to-wire harness
connection for gas dryer.
If there is continuity, go to step 6.•
If there is no continuity, disconnect the •
white wire of the harness from the power
cord at the location illustrated in Figure
5. Test the continuity of the power cord
neutral wire as illustrated in Figure 6.
If an open circuit is found, replace the
power cord. Otherwise, go to step 6.
COM
N
N
G
G
L1
Power Cord
Plug
L1
Figure 6. Power cord terminals, gas dryer.
6. In a similar way, check the continuity
between the L1 terminal of the plug and
P9-2 (black wire) on the control board. See
Figure 17.
If there is continuity, go to step 8.•
If there is no continuity, check the •
continuity of the power cord in a similar
way to that illustrated in Figure 6, but for
power cord’s L1 wire.
If an open circuit is found, replace the •
power cord. Otherwise, go to step 7.
7. Replace the main harness.
8. Visually check that the P5 connector is
inserted all the way into the machine
control electronics.
9. Visually check that the console electronics
and housing assembly is properly inserted
into the front console.
10. If both visual checks pass, replace the
console electronics, housing assembly,
and all parts and panels before operating.
11. Plug in dryer or reconnect power.
12. Perform the Console Buttons and Indicators
Diagnostic test to verify repair.
4. Access the machine control electronics
without disconnecting any wiring to the
controlboard.Seegure16.
5. With an ohmmeter, check for continuity
between the neutral (N) terminal of the plug
and P8-3 (white wire) on the machine control
board.Theleft-handsideofgure6shows
the position of the neutral terminal (N) on the
power cord plug. Also see Figure 17.