Specifications

6-3
Diagnostic: Door Switch
Opening the door should cause a beep and an
alphanumeric number to be displayed. Closing
the door should cause a beep and 88 to be
displayed.
If opening the door fails to cause a beep and a
number and letter to be displayed, go to TEST
#6.
Diagnostic: Moisture Sensor
Open the door and locate two metal strips
on the face of the lint screen housing. Bridge
thesestrips with a wet cloth or a nger. If a
beep is heard and an alphanumeric number is
displayed on the console, the sensor is OK. If
not, or if a beep tone is heard before bridging
the moisture strips, go to TEST #4.
Diagnostic: Motor, Heater, and Console ID
Close the door. Press the START button. The
motor and heater will turn on, and the display
will show one of the following Console IDs: 9b,
9C, 9d, 9E, or 9F.
While running, press the START button again.
The motor and heater will turn off, and the
display will show 88.
If none of the Console IDs are displayed, •
replace the console electronics and housing
assembly. See Accessing & Removing the
Electronic Assemblies.
If the motor does not turn on, go to TEST •
#2.
If no heat is detected, go to TEST #3.•
DE-ACTIVATING THE DIAGNOSTIC
TEST MODE
Press the PAUSE/CANCEL button to exit
diagnostics.
Power button controls Status indicators at left
and the Lock/Unlock Control indicator
This button
controls the
right digit
This button
controls the
left digit
Backlit button
controls its own
indicator
Button controls
above button
indicators
Button controls
all
above button
indicators
Button controls
all
above button
indicators
Figure 1. Console Diagnostics.