Specifications

4-13
d) Lift the locking tabs on the top and
bottom of the motor harness plug and
disconnect the plug from the motor
terminals.
e) Remove the two mounting screws from
the drive motor, then pull the motor to
the right until the two motor bracket
tabs are out of the chassis floor slots,
and remove the drive motor.
6. To remove the belt switch:
a) Remove the drive motor from the dryer
(see step 5).
b) Unhook the end of the spring from the
idler pulley arm.
c) Remove the 3/8˝ hex-head screw
from the idler pulley arm and remove
the arm from the motor.
Drive Motor
Plug Tabs
Drive Motor
Screws
Drive Motor
Floor Slots
Unhook Spring
Idler
Pulley Arm
Screw
d) Remove the two screws from the belt
switch and remove it from the motor.
e) Disconnect the two blue wires from
the belt switch terminals.
Wire Connectors
Belt Switch Screws