Specifications

3-3
7. Press and hold START for approximately 1
second until dryer starts. Be sure the door
is closed.
If you do not press Start within 5 minutes •
of selecting a cycle, the dryer automati-
cally shuts off.
STOPPING OR RESTARTING
THE DRYER
To pause/stop the dryer at any time
Open the door or press PAUSE/CANCEL
once.
To restart the dryer
Close the door. Press and hold START until
dryer starts.
To cancel the dryer at any time
Press PAUSE/CANCEL twice.
NOTE: Drying will continue from where the
cycle was interrupted if you close the door
and press Start within 5 minutes. If the cycle is
interrupted for more than 5 minutes, the dryer
will shut off. Select new cycle settings before
restarting the dryer.
LOCK CONTROLS
This feature allows you to lock your settings
to avoid unintended use of the dryer. You can
also use the control lock feature to avoid un-
intended cycle or option changes during dryer
operation.
To enable the control lock feature:
Press and hold CYCLE SIGNAL button for 3
seconds. The CONTROLS LOCKED icon lights
up, and a single beep tone is heard. To unlock,
press and hold CYCLE SIGNAL button for 3
seconds. The indicator light turns off.
DRYING AND CYCLE TIPS
Select the correct cycle and dryness level or
temperature for your load. If an Sensor Dry
Cycle is running, the display shows the esti-
mated cycle time when your dryer is automati-
cally sensing the dryness level of your load.
If a Timed Dry Cycle is running, the display
shows the exact number of minutes remaining
in the cycle.
Cool Down tumbles the load without heat during
the last few minutes of all cycles. Cool Down
makes the loads easier to handle and reduces
wrinkling. The length of the Cool Down depends
on the load size and dryness level.
Drying tips
Follow care label directions when they are •
available.
If desired, add a fabric softener sheet. Follow •
package instructions.
Remove the load from the dryer as soon as •
tumbling stops to reduce wrinkling. This is
especially important for permanent press,
knits and synthetic fabrics.
Avoid drying heavy work clothes with lighter •
fabrics. This could cause overdrying of lighter
fabrics, leading to increased shrinkage or
wrinkling.
Cycle tips
Dry most loads using the preset cycle set-•
tings.
Refer to the Sensor Dry Cycles or Timed Dry •
Cycles Settings chart (in the “Cycles” section)
for a guide to drying various loads.
Drying temperature and Dryness are •
preset when you choose an Auto Cycle.
You can choose a different dryness
level, depending on your load by press-
ing the Dryness Level to select MORE
or LESS.
NOTE: You cannot use the Timed Dry
Cycle Adjust Up or Down arrow buttons
and you cannot modify temperature with
the Sensor Dry cycles.
If you wish to adjust the cycle length of •
a Timed Dry Cycle, press the Timed Dry
Cycle Adjust up or down arrow buttons.
Adjust the temperature of a Timed Dry
Cycle by pressing TEMPERATURE until
the desired temperature is selected.
NOTE: You cannot use the Dryness Level
with Timed Dry Cycles.