Specifications

3-2
Follow these basic steps to start your dryer.
Please refer to specic sections of this manual
for more detailed information.
1. Clean lint screen before each load. See
“Cleaning the Lint Screen.”
2. Place laundry into dryer and shut door.
3. Press POWER.
4. Select a Sensor Dry or Timed Dry Cycle. The
preset settings for Sensor Dry or Timed Dry
Cycles will illuminate. The estimated (Sen-
sor Dry cycle) or actual (Timed Dry) cycle
time (in minutes) will show in the display.
NOTE: A default time is displayed when an
automatic cycle is selected. During the rst
few minutes of the drying process, the cycle
time may automatically vary from the default
time based on the size and fabric type of the
load. Toward the end of the drying process,
the estimated time display will adjust again,
showing the nal drying time.
To use a Sensor Dry Cycle
Select a Sensor Dry Cycle. Sensor Dry Cycles •
are preset to Normal..
Select DRYNESS LEVEL to adjust how dry •
you want the load. As the cycle runs, the
control senses the dryness of the load and
adjusts the time automatically for the selected
dryness level.
To make changes to the Dryness and/or
Options during an Auto Cycle:
Press PAUSE/CANCEL once.•
Adjust Dryness and/or Options.•
NOTE: Dryness Level selections can be made
only while using Sensor Dry Cycles. Selecting
More, Normal or Less automatically adjusts the
sensed time needed.
Sensor Dry cycles take the guesswork out of dry-
ing time and enhance fabric care. The amount
of time that is displayed is the estimated time
remaining in the cycle.
To use a Timed Dry Cycle
Select a Timed Dry Cycle.•
Press the Timed Dry Cycle Adjust up or down •
arrow buttons until the desired drying time is
displayed. Tap the Timed Dry Cycle Adjust
up or down arrow buttons and the time will
change by 1-minute intervals. Press and
hold the Timed Dry Cycle Adjust up or down
arrow buttons, and the time will change by
5-minute intervals.
NOTE: The Timed Dry Cycle Adjust feature
can be used only with Timed Dry Cycles.
Press TEMPERATURE until the desired •
temperature illuminates.
To make changes to Time and/or options
during a Timed Dry Cycle:
Press PAUSE/CANCEL once.•
Adjust the Time and/or Options.•
5. (OPTIONAL STEP) If desired, select WRIN-
KLE PREVENT
™
feature. For more details,
see “WRINKLE PREVENT
™
Feature” in
“Additional Features.”
6. (OPTIONAL STEP) The Cycle Signal is
preset to ON. If desired, you may turn the
Cycle Signal OFF.