Specifications

2-22
4. Reinstall plug strips on opposite side of
the inner door.
5. Check for fingerprints on the glass. Clean
glass if necessary.
6. Place the inner door assembly inside the
outer door assembly. To fit correctly, the
inner door assembly edge fits completely
inside the outer door assembly edge.
7. Reassemble the inner and outer door as-
semblies with the 6 screws.
Reverse the strike
1. Use a small flat-blade screwdriver to re-
move plug strip from the dryer door open-
ing. Slide the head of the screwdriver un-
der the plugs, being certain not to scratch
the dryer surface. Lift up.
2. Remove the strike.
3. Insert strike and plug strip on the opposite
side.
A. Plug strip (cannot be seen from this angle)
B. Door strike
B
A
Reinstall the door
1. Reattach door to dryer front panel with the
4 screws.
A. Dryer front panel
B. Door assembly
A
B
2. Check for fingerprints on the glass. Clean
the glass if necessary.
3. Close door and check that it latches se-
curely.
COMPLETE INSTALLATION
1. Check that all parts are now installed. If
there is an extra part, go back through the
steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materi-
als.
4. Check the dryer’s final location. Be sure
the vent is not crushed or kinked.
5. Check that the dryer is level. See “Level
Dryer.”
6. Plug in dryer or reconnect power.
7. Remove any protective film on the console
and any tape remaining on the dryer.
8. Read “Dryer Use” in the Dryer User In-
structions.
9. Wipe the dryer drum interior thoroughly
with a damp cloth to remove any dust.