Specifications

2-21
A. Dryer front panel
B. Door assembly
A
B
A. Inner ring
B. Outer ring
A
B
2. Lay the door assembly on a flat, protected
surface with the inside (inner door assem-
bly) facing up.
3. Remove the 6 Phillips head screws to re-
lease the outer door assembly from the
inner door assembly, as indicated below.
See illustration. It is important that you re-
move only the 6 indicated screws.
Remove the door assembly
1. Remove the 4 screws that hold the door
hinge on the front panel of the dryer.
4. Lift the inner door assembly off the outer
door assembly.
5. Disengage locking tabs by rotating inner
ring clockwise. See illustration.
A. Door hinge
B. Plug strips
C. Hinge cover
A
C
B
6. Turn inner ring 180° and lock tabs into
place.
Reverse hinge
1. Use a small flat-blade screwdriver to re-
move 2 plug strips from the inner door.
Slide the head of the screwdriver under
the plugs, being certain not to scratch the
inner door surface. Lift up.
2. Remove hinge cover.
3. Remove the 4 screws that attach to the in-
ner door hinge and move the hinge to the
other side. Reinstall the 4 screws.
A. Door hinge
A