Specifications

2-2
WARNING
LOCATION REQUIREMENTS
Explosion Hazard
Keep flammable materials and vapors,
such as gasoline, away from dryer.
Place dryer at least 18 inches (46 cm)
above the floor for a garage installation.
Failure to do so can result in death,
explosion, or fire.
You will need
A location that allows for proper exhaust in-•
stallation. See “Venting Requirements.”
Electric Models Only: A separate 30-amp •
circuit.
If you are using a power cord, a grounded •
electrical outlet located within 2 ft (61 cm)
of either side of the dryer. See “Electrical
Requirements.”
A sturdy floor to support the total dryer •
weight of 127 lbs (57.6 kg). The combined
weight of a companion appliance should
also be considered.
A level floor with a maximum slope of •
1˝(2.5 cm) under entire dryer. (If slope is
greater than 1˝ [2.5 cm], install Extended
Dryer Feet Kit, Part No. 279810.) Clothes
may not tumble properly and automatic
sensor cycles may not operate correctly if
dryer is not level.
For a garage installation, you will need to •
place the dryer at least 18˝ (46 cm) above
the floor. If using a pedestal, you will need
18˝ (46 cm) to the bottom of the dryer.
Do not operate your dryer at temperatures
below 45°F (7°C). At lower temperatures, the
dryer might not shut off at the end of an auto-
matic cycle. Drying times can be extended.
OPTIONS
Pedestal
Are you placing the dryer on a pedestal?
You have the option of purchasing pedestals
of different heights separately for this dryer.
You may select a 10˝ (25.4 cm) pedestal or a
15.5˝ (39.4 cm) pedestal with a shelf and bin
dividers. These pedestals will add to the total
height of the unit for a total height of approxi-
mately 46˝ (116.8 cm) or 51.5˝ (130.8 cm).
For a garage installation, you will need to
place the 10" (25.4 cm) pedestal at least 9"
(22.9 cm) above the floor. You will need to
place the 15.5" (39.4 cm) pedestal at least 3"
(7.6 cm) above the floor.
Optional pedestal (15.5˝ [39.4 cm] model shown)
To order, call the dealer from whom you pur-
chased your dryer or refer to the “Assistance
or Service” section.
Stack Kit
Are you planning to stack your Epic z
™
washer
and dryer? To do so, you will need to purchase
a Stack Kit.
To order, call the dealer from whom you pur-
chased your dryer or refer to the “Assistance
or Service” section. Ask for Part Number
8212640.
P rebmuN traProloCthgieH latsede
10" (25.4 cm) White MHP1000SQ0
10" (25.4 cm) 0BS0001PHMkcalB
15.5" (39.4 cm) White MHP1500SQ0
15.5" (39.4 cm) 0BS0051PHMkcalB
15.5" (39.4 cm) P a cic Blue MHP1500SK0