Specifications

GAS REQUIREMENTS

OBSERVE ALL GOVERNING CODES AND ORDINANCES.

Gas supply:

Check that dryer is equipped with the correct burner for the

particular type of gas supply. Burner information will be found

on the model/serial rating plate in the door well of the dryer. If

this information does not agree with the type of gas available,

see your dealer.

Natural Gas:

This dryer is factory adjusted for use with NATURAL GAS (G20),

and no further adjustment should be required at installation.

L.P. Gas:

This dryer is also certied for use with L.P. (propane or butane)

gases with appropriate conversion. No attempt shall be made to

convert the appliance from the gas specied on the model/serial

rating plate for use with a different gas without consulting the

serving gas supplier.

Conversion must be done by a qualied service technician.

Gas conversion kits are available for purchase from your dealer.

Full instructions are supplied with the kit.

Supply Line Requirements

Provide a rigid gas supply line to the dryer location. It should be

minimum 12.5 mm (1/2") ID. When acceptable to the gas supplier

and local codes, 10 mm (3/8") ID rigid supply line may be used

for lengths under 6.1 m (20'). Pipe-joint compounds resistant to

the action of L.P. gas must be used.

NOTE: In accordance with the European EMC Directive

(89/336/EEC) the maximum electricity supply system impedance

to which the electric dryer should be connected is declared to be

0.29 Ohm + J0.18 Ohm.

This dryer has a Maximum power absorption/usage of 4700 watts.

If code permits and an additional earth bond wire is used, it is

recommended that certied electrician determine that the earth

bond path is adequate.

Electrical Safety Standards: The manufacturer has chosen

compliance with IEC/EN.60335 standards as the most

appropriate for this product.

Do not use an adapter.

Recommended Earthing Method

■ It is your responsibility to contact a qualied electrical installer

to ensure that the electrical installation is adequate and in

conformance with all local codes and ordinances.