\ IMPORTANT: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use. 24” and 27” Electric Built-in Single and Double Ovens Part No. 3183636 Rev.
4” Double oven Cablnet I q---- i I I -I i-r 22-l/2” min. cabinet openlng width I Oven control console I See Note.” 1 1 I I I 44’ cabinet openlng helght 1 2%j/4” cabinet min. 4-112” exposed trtm. door and handle depth (2-l/2” wlthout handle) z$::g I I i I I I rc-\ Read the electrical and carpentry instructions. Proper installation is your responsibility. A qualified technician should install this oven. Make sure you have everything necessary for correct installation.
24” Single oven II Cabinet door ‘Note: There must be 1” mln. between bottom of cabinet door and top of oven console. 24” min. overall cabinet wldth ’ II 211/T’ mln. I I Oven control console 4-W exposed tdm, door and handle depth fW&‘ltho~ I 27-5/5”recessed height II 29-3/V overall height See Note.’ Do Not seal oven to cabinets. 31-l/4” mlrY. recommended so oven door, when open, Is 38’ from floor. 24” min.
Electrical connection Electrical requirements IMPORTANT: Save Installation Instructions electrical inspector’s use. grounding that a that the for the local A . This appliance must be connected to the proper electrical voltage and frequency as specified on the serial/rating plate located behind the oven door (double oven models upper oven) on the front frame. Models rated at 7.0 kw on 240 volts (5.3 kw on 208 volts) or more require a separate 40ampere circuit. Fuse both sides of the line.
Now start... with oven in kitchen. 1 n Remove shipping materials, tape, and protective film from oven. Do Not remove shipping base at this time. 2 n Remove the racks and other parts from inside the oven. Personal Injury Hazard Use both hands to remove oven doors l Grasp only the sides of oven doors. l Do Not use handle or any portion of the front frame or trim for lifting. l Because of the weight and size of the ovens, two or more people are needed to move and safely install the ovens.
13 Replace the oven racks. Replace the single oven or upper double oven door by partially fitting the door hinges into the hinge slots. Pull door slightly toward you; then slide door completely in place. Reinstall the two oven-door screws (if required for your oven door). If door does not close, you have not pushed hinges completely into frame. Repeat for lower oven door. 11 Turn on the power supply. ‘PF” should appear in the’temperature display and “88:88” should appear in the clock display.
If the oven does not operate... l l Check that the circuit breaker is not tripped or the house fuse blown. See Use and Care Guide for troubleshooting checklist. NOTE: Refer to Use and Care Guide for operating instructions and cleaning instructions. If you need assistance... If you need service... The Whirlpool Consumer Assistance Center will answer any questions about operating or maintaining your oven not covered in the Installation Instructions.
