Operation Manual

NOMAD™ - NRT202
O
PERATING
I
NSTRUCTIONS
PAGE 9 of 15
The message has been sent (00%) and confirmation that operator 1 is
recognised in the system is shown by displaying their name. If operator 1
had not been recognised then the following would be displayed.
If the battery starts to get low the “Batt” symbol will alternate with the battery
voltage in the lower left corner. When the battery has insufficient power to
operate the terminal reliably the “Batt” symbol will be displayed
continuously.
4.3 PAGING FACILITY
There is a facility within the NOMAD system to send short text messages to
specific terminals. When such a message is received and the terminal is in
standby mode it will give a series of beeps and the standard display will be
replaced by the text message, which will flash on and off.
To cancel the message and return to normal standby mode press and hold
the 4 and 6 keys as if about to enter data. This will cancel the page
message. Press the ‘CLR’ key to return to standby mode.
4.4 FEEDBACK
If operator feedback is enabled on the NOMAD system a message is sent
to the operator after each task code (for which feedback has been defined)
has been received by the system. When the terminal receives the message
a double beep will be emitted.