Operation Manual

NOMAD™ - NRT202

PERATING

NSTRUCTIONS

PAGE 11 of 15

“Clock In” the user is prompted for “Operator” and should enter their works

number.

The number of digits that the terminal will accept will vary depending on the

parameter and the setting made in the NOMAD system.

Note that the terminal will only accept codes other than “Clock In” (code 0) if

the user has clocked in. Once clocked in the prompt for code 0 will change

to “Clock Out”. After pressing enter to “Clock Out” the user will be prompted

to “Confirm”. This is done by pressing the ‘ENT’ key again.

5.2 MULTI-USER MODE

To exit the standby mode press and hold the 4 and the 6 keys together. A

prompt inviting the user to “Enter Operator” will be displayed.

Enter the operator number for the task to be entered and press ‘ENT’. A

prompt inviting the user to “Enter Time” will be displayed.

The current time will be display in the lower right corner of the screen. To

accept this press the ‘ENT’ key, else key in the required time and press the

‘ENT’ key.

The rest of the process is as per section 5.1 above.

6. RFID ENTRIES

All entries can also be made with the built in RFID reader. Pressing the

scan will activate the RFID reader for 10 seconds or until a valid tag is

found. The terminal should be placed with the rear of the casing adjacent to

the RFID tag/card to be read.

6.1 WARNING TONES

There are three possible results of reading an RFID tag and each produce a

different type of beep from the terminal.

 The tag is read and accepted – single beep

 The tag is read correctly but rejected (for example, an attempt to

enter a task before being clocked in) – three distinct beeps.