User's Manual

NOMAD - NRT202
O
PERATING
I
NSTRUCTIONS
P
AGE
9 of
9
Note that the terminal will only accept codes other than Clock In (code 0) if
the user has clocked in. Once clocked in the prompt for code 0 will change
to Clock Out . After pressing enter to Clock Out the user will be prompted
to Confirm . This is done by pressing the ENT key again.
5.2 MULTI - USER MODE
To exit the standby mode press and hold the 4 and the 6 keys together. A
prompt inviting the user to Enter Operator will be displayed.
Enter the operator number for the task to be entered and press ENT . A
prompt inviting the user to Enter Time will be displayed.
The current time will be display in the lower right corner of the screen. To
accept this press the ENT key, else key in the required time and press the
ENT key.
The rest of the process is as per section 5.1 above.
6. BARCODE ENTRIES
All entries can also be made with the built in barcode scanner. Pressing the
down arrow key will activate the barcode scanner for 5 seconds or until a
valid barcode is found. The terminal should be placed in contact with the
object to which the barcode is fixed so that it can be seen that the red
illumination covers the barcode.