User's Manual

NOMAD - NRT202
O
PERATING
I
NSTRUCTIONS
P
AGE
8 of
8
4.5 MULTI - USER
If in multi-user mode the operator number/name will be replaced by M-
USER
5. ENTERING DATA
The normal state of the terminal is standby - the keypad is locked against
accidental operation.
5.1 NORMAL MODE
To exit the standby mode press and hold the 4 and the 6 keys together. A
prompt inviting the user to Enter Command will be displayed.
Note that all or some of the prompts may have been redefined in the
NOMAD system depending on the language settings.
Key in the number of the task to be entered. As the digits are keyed in a
menu prompt will be displayed if the task code is one that has been defined.
Alternatively, if the task code is not known press and hold up or down arrow
keys to scroll up and down through the available task codes.
Press the ENT key when the desired task code is displayed. Further
pro mpts may be displayed requesting the user to in turn enter any additional
parameters required by the task code. For example, after pressing ENT for
Clock In the user is prompted for Operator and should enter their works
number.
The number of digits that the terminal will accept will vary depending on the
parameter and the setting made in the NOMAD system.