User Manual

NOMAD™ - NRT102
OPERATING INSTRUCTIONS
PAGE 7 of 10
4.4 FEEDBACK
If operator feedback is enabled on the NOMAD system a message is sent to
the operator after each job code (for which feedback has been defined) has
been received by the system. When the terminal receives the message a
single beep will be emitted.
To view the feedback message press and hold the ‘SHIFT’ key while in
standby mode. Releasing the ‘SHIFT’ key will return the terminal to standby
mode.
4.5 MULTI-USER
If in multi-user mode the operator name will be replaced by “M-USER”
5. ENTERING DATA
The normal state of the terminal is standby - the keypad is locked against
accidental operation.
5.1 NORMAL MODE
To exit the standby mode press and hold the 4 and the 6 keys together. A
prompt inviting the user to “Enter Command” will be displayed.
Note that all or some of the prompts may have been redefined in the
NOMAD system depending on the language settings.
Key in the number of the job or task to be entered. As the digits are keyed
in a menu prompt will be displayed if the job code is one that has been
defined.
Alternatively, if the job code is not known press and hold ‘SHIFT’ key and
then use the 3 and 9 keys to scroll up and down through the available job
codes.
M-USER 06:30
123 00%