User Manual

NOMAD™ - NRT102
OPERATING INSTRUCTIONS
PAGE 5 of 10
3.2 CHANGING OPERATING MODES
The terminal can be set to be used by an individual or by a group. The
normal mode after initialisation is for individual use.
Multi-user mode is intended for the situation where a supervisor is entering
in data for several employees. It allows the operator number and time to be
set for each data entry.
To change modes remove the terminal from its charge bracket to cause the
startup message to be displayed. While this message is displayed press
and hold the 4 and the ‘CLR’ keys. Each time this is performed the mode
will toggle between normal and multi-user.
4. THE LCD SCREEN
4.1 STARTUP MESSAGE
The startup message indicates the software version for the terminal along
with the system and node numbers.
Hoogendoorn
EN2 3.2.6 1#123
In the example above the software is variant EN2, version 3.2.6. The
system number is 1 and the node number is 123.
4.2 STANDBY MODE
The default display for the terminal takes the general form below,
A typical display after removing a terminal from the charging bracket. It
shows the time, the node number and the percentage of memory used.
06:30
123 00%
Hoogendoorn
EN2 3.2.6 1#123