Owner's manual

(2)
1. Place each Actuator Column Assembly (1)
upside down with the cord toward the floor.
CAUTION: Do not pinch Cord Assembly
2. Position the XR Foot or the 14" Welded Foot
(2 or 3) over Actuator Column Assembly (1) with
the longer portion of the Foot toward the front
(Welded Foot is symmetrical). The Actuator
column 'FRONT' is determined by the position of
the cross channel clip that is welded on each
column. Position this clip to the rear.
3. Attach the XR Foot and the 14" Welded Foot
(2 or 3) to the Actuator Column Assembly (1)
with four M6 x 16 mm Screws (E1) and Star
Washers (E2).
4. Screw the Glides (E3) into the two tapped
holes in the bottom of 14" Welded Foot (3).
5. Place the assembled 14" Welded Foot
Actuator Column upright and attach the Corner
Bracket (7). Slide the Corner Bracket onto the
tapered channel clip on the column. Gently tap
Bracket in place with a Rubber Mallet to assure
a tight fit.
6. Place the outer Actuator column assemblies
upright and attach the Cross Channels (4 & 5).
Position the Cross Channel flange with end
notches toward the floor. Slide the Cross
Channel bracket onto the tapered channel clip
on each Column. Gently tap the Cross
Channels in place with a Rubber Mallet to
assure a tight fit.
7. Align the last 4 holes in each Cross Channel
with the 4 holes in the Corner Bracket mounted
to the Corner Actuator Column and attach with
four 1/4-20 X 1/2 Screws (E4) and 1/4-20 KEPS
Nuts (E5).
8. In the event that you must reposition the
Actuator cord. Gently remove the cord and
strain relief from the notch in the top of each
Column Assembly (1). Position the cords so that
they are toward the center of the assembled
base. Insert the strain relief into the appropriate
Column notch. Attach Top Plate (6) to each
Actuator Column with four M6 x 16 mm Screws
(E1) and Star Washers (E2).
9. Attach the Memory Switch (9), Main Cord (10),
and Connector Cables (11 and 12) to the Control
Box (8).