Owner manual

Ring
Terminal (2)
Cable (1B)
NOTE: Please count and inspect all pieces before disposing of any carton or packing materials.
When ordering components, specific color and/or size information may be required.
Contact a Mayline Customer Service Representative. 1-800-822-8037
INSTRUCTIONS FOR RESTRINGING ABOVE
BOARD MAYLINE STRAIGHTEDGE
1. Remove Pulley Housing, Brake Know Washer and Brake Knob.
Repeat procedure on other end. Fig. 1
2. Remove old cable by pulling cable out of slot in Straightedge.
3. If using Bulk Cable, total cable length required: (3) x (length of
straightedge) + 8 feet.
4. Cut total cable length into two equal lengths.
5. Feed on end of Cable 1B through slot in straightedge cap until
approximately 6 inches extends through opposite end. Fig. 2
6. Tape end of Cable 1A to Cable 1B and pull through until 6
inches of Cable 1A is through opposite end. Fig. 2 Remove
tape.
7. Crimp ring Terminal (2) onto the upper ends of cables 1A and 1B.
8. Replace pulley housing / brake assembly. Fig. 1
Fig. 2
Cable (1B)
Ring
Terminal (2)
Ball bearing
Pulley
Tape
Cable (1A)
Fig. #1
Brake Shoe
COMPONENTS:
REF.# QTY. DESCRIPTION PART No.
1 CALL~~ Cable Coil CALL~~
2 2 * Ring Terminal Q6
* Ring Terminal (Item 2) must be ordered separately when
buying cable in Bulk Spool
CATALOG No.
7355100
7355300
7355A
7355B
7355C
Washer
Brake Knob
Pulley
Housing
(1)