Instruction Manual

Kwik-File, LLC

Tambour Door Consoles

ASSEMBLY INSTRUCTIONS

(CL36T, CH36T, CL48T, CH48T, CL60T, CH60T, CL72T & CH72T)

1. Remove Console from packaging.

2. Tip unit on its back and install (4) leg glides

into weld nuts. Set Console upright and place

into position. Level Console by adjusting the

leg glides. (Fig 1.1)

Replacement Part:

910080R - Kit of (4)

Unit Ships

with

Leveling Leg

Glides

PAGE 1
Kwik-File, LLC Tambour Door Consoles ASSEMBLY INSTRUCTIONS (CL36T, CH36T, CL48T, CH48T, CL60T, CH60T, CL72T & CH72T) Unit Ships with Leveling Leg Glides Replacement Part: 910080R - Kit of (4) 1. Remove Console from packaging. 2. Tip unit on its back and install (4) leg glides into weld nuts. Set Console upright and place into position. Level Console by adjusting the leg glides. (Fig 1.
PAGE 2
3. Remove (2) door stops in top track which were holding doors open during shipment. Remove (2) screws in bottom shelf that were utilized for shipping. Discard these parts. ( 4. Console unit install is complete. Console Tambour Shelf Install (Optional Item) CTS36, CTS48, CTS60 & CTS72 1. Push doors to their fully open position. 2. Install (3) shelf hooks per side at desired height for shelf (note: there will be (2) extra shelf hooks sent with shelf). Place shelf into position and press into shelf hooks.