Manual

ManualsBrandsMayline ManualsFurnitureBoat-Shaped Table – 120" x 48 Boat Aberdeen Series"

ASSEMBLY INSTRUCTIONS

CALL 1-800-822-8037 FOR ASSISTANCE

PARTS LIST

Name Part

Qty.

Spare

Qty

C 24 2

P/N ACTB10 REV 08 07/22/14

Wood Dowel

REALS004

Spare

Qty

Qty.

PartName

REALS003

Cam Post

REALS001

Cam Fastener

REALS067

Leveler

Cam Sticker

REALS102**

224

ACBT10HB

24 2

M6 x 15mm

REALS043

Plate

REALS167

REALS118

Center Plate

Items with HB are in

hardware box

Grommet

REALS099

Conference Table 120" x 48"

Model No. ACTB10

Aberdeen Series

www.mayline.com

re l

ffice

Summary of content (4 pages)

PAGE 1
re loffice PARTS LIST Aberdeen Series Conference Table 120" x 48" Model No. ACTB10 TM Name Qty. Spare Part Name Qty HB A Qty. Spare Part Qty HB F 14 1 2 REALS099 Grommet REALS004 Wood Dowel HB B 24 2 G REALS003 Cam Post 2 REALS167 Plate HB C H 24 2 REALS118 Center Plate REALS001 Cam Fastener HB D 1 HB J 24 2 24 2 REALS043 M6 x 15mm REALS102** Cam Sticker HB E ASSEMBLY INSTRUCTIONS CALL 1-800-822-8037 FOR ASSISTANCE P/N ACTB10 REV 08 07/22/14 www.mayline.
PAGE 2
PARTS LIST Name Part L Qty. Name 2 N ABT10** Top Part Qty. 1 DO NOT assemble table with top to floor. Table must be assembled in an upright position only. 2 Insert Wood Dowels (A) and Cams (C) into Center Panel (M). Install Cam Posts (B) into threaded inserts in Modesty Panels (P). Secure Modesty Panels (P) to Center Panel (M) by turning Cams (C).
PAGE 3
Insert Wood Dowels (A) into top edge of each Modesty Panel (P). Insert Wood Dowels (A) and Cams (C) into the end of each Modesty Panel (P). Install Cam Posts (B) into threaded inserts in Table Legs (N). Install Leveler (E) and insert Cams (C) into the Table Legs (N). Secure Modesty Panels (P) to Table Legs (N) by turning Cams (C). 4 Install Cam Posts (B) into threaded inserts into the underside of each Top (L). Attach Plates (H & G) to the underside of Top (L) using Screws (J).
PAGE 4
5 Place each Top (L) onto the base. Fasten tops (L) together using Plates (G, H) and Screws (J). Secure Tops (L) to base by turning Cams (C). Insert Grommet (F) into Tops (L). Apply Cam Stickers (D) to all exposed Cams (C).