User's Manual

Performance Tips:
1. Do not drive on grass, sand, carpet or go through water.
2. Do not drive in windy or rainy weather.
3. Avoid colliding with hard surfaces.
4. Switch OFF the Vehicle and Transmitter when not in use.
5. Remove all Batteries from the Vehicle and Transmitter when not in use.
6. Fully extend the antenna for best performance and do not point the antenna toward the vehicle.
7. Keep fingers, hair and loose clothing away from the wheels.
8. The operating range can be affected by a variety of factors:
a) Weak Transmitter Battery, or under-charged Battery Pack.
9.
Cautions :
The 9.6V Battery Pack must be charged before use by utilizing the 4-Hour Battery Pack Charger which is included.
Do not overcharge the Battery Pack. Do not charge for more than 6 hours.
Do not charge the Battery Pack if it shows leakage, corrosion, or has loose or exposed wires or other damage.
Do not cover the Battery Pack with any sort of material while charging.
Do not dispose of the Battery in fire.
Do not dismantle the Battery or Charger, and do not cut the Battery or Charger cables.
The Battery Pack will be warm after charging, and hot after use in a vehicle.
The supply terminals are not to be short-circuited.
Rechargeable Batteries are to be removed from the toy before being charged.
Rechargeable Batteries are only to be charged under adult supervision.
FCC Label Compliance Statement:
81021RC49
FCC ID : PKG81021RC49
Tested To Comply with FCC Standards
FOR HOME OR OFFICE USE
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
- Consult the dealer or an experienced radio/TV technician for help.
b) Interference from other items that emit radio frequency signals such as another R/C item on the same
frequency, CB radios, cordless phones, high voltage transformers, etc.
The Manufacturer is not responsible for any Radio or TV interference caused by unauthorized modifications to this equipment. Such
modifications could void the User's Authority to operate the equipment.
Do not touch the Battery Pack when it is hot. Wait until the Battery Pack cools before installing it in the vehicle and before recharging.
Note that the 9V Battery is non-rechargeable and is not to be recharged. Only batteries of the same or equivalent type as
recommended are to be used. It will need replacement when transmission is poor. Exhausted batteries are to be removed from the
Transmitter.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Outdoor usage is recommended in order to get optimal control range (100 feet or 30 meters).
Regular examination of Battery Charger for any damage to their cord, plug, enclosure and other parts, and that, in the event of such
damage, it must not be used with the Charger or Battery Pack charge until such damage has been repaired.
Charge Only Ni-Cd Type (700mAH Max.) rechargeable Battery Packs. Other types of Batteries may burst causing injury to persons and
damage. This power unit is intended to be correctly orientated in a vertical or floor mount position.