MAXXUS ® PRO SPK-21 FITNESS CYCLE OWNER’S MANUAL
Dear customer, Thank you for purchasing MAXXUS® Pro SPK-21 Fitness Cycle. This product was designed to meet your workout needs and provide you with a healthier life. Before you begin using this product, please read the Owner’s Manual completely and thoroughly and follow the instructions of all WARNING and CAUTION labels. If you have any questions about this product or are in need of replacement parts, please contact Customer Service by calling (909) 212-5555 or emailing us at: info@goldendesignsinc.
____________________________________________________________ SAFETY INSTRUCTIONS Before you start to assemble and operate this product, please carefully read the Owner’s Manual in its entirety. Please follow all instructions in this Owner’s Manual as described. Be sure to read through the Safety Instructions below and keep this Owner’s Manual for future reference. ● Misuse of this product may cause serious injury. ● Consult your physician before starting any exercise program.
____________________________________________________________ PARTS LIST Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 Description Main Frame Rear Foot Bar Front Foot Bar U-Zone Bar Seat Post Handle Post Seat Slider Handle Bar End Cap Adjustable Pad Move Wheel Hex Head Bolt Nylon Nut Washer Hex Head Bolt Cap Nut End Cap Bearing Bearing S Nut Belt Wheel Rod Left Cover Right Cover Top Left Cover Top Right Cover Rear Cover Front Left Cover Front
____________________________________________________________ EXPLODED DRAWING 4
____________________________________________________________ PACKING PARTS LIST 5
____________________________________________________________ ASSEMBLY ● ● ● Read the Owner’s Manual in its entirety before assembly. Remove all parts from the box. Check to confirm receipt of all parts and quantities shown in the Packing Parts List on page 5. (Note: Some parts may be pre-assembled.) STEP 2 Slide the Front Foot Bar (3) to the front of the Main Frame (1) adding two Washers (14), two Spring Washers (68), two Cap Nuts (16), and two Hex Head Bolts (15) as shown in Figure 1.
____________________________________________________________ ASSEMBLY STEP 4 Attach the Left Pedal (55) and Right Pedal (56) to the Left Crank (53) and Right Crank (54) as shown in Figure 2. ** Tighten the Left & Right Pedals used in STEP 4 with the Spanner Tool (67). STEP 5 Insert the Seat Post (5) into the tube of the Main Frame (1) with Knob (60) as shown in Figure 3. ** Hand tighten ONLY. STEP 6 Affix the Seat (62) on the bar of the Seat Slider (7).
____________________________________________________________ ASSEMBLY STEP 8 Insert the bolts on the underside of each Elbow Pad (70). Next, slide the other end of the bolts into the holes on the Handle Bar (8) and screw on one nut (69) on each side as shown in Figure 4. There are two holes on either side of the handle bar (8) for elbow pad (70) adjustments. You can choose the hole which is suitable for you and tighten the elbow pad (70) onto the handle bar (8).
____________________________________________________________ HOW TO USE THE BIKE After assembling the bike and tightening all appropriate components as instructed, you can now begin using bike. Handle bar, seat, and elbow pad adjustments allow users to adjust the bike to fit one's size and body frame. Streamline surface design fits in with ergonomics and increases comfort.
____________________________________________________________ SERIAL NUMBER LABEL The diagram below shows the location of the Serial Number Label. The serial number is indicated on the label affixed to the lower part of the Main Frame. (Note: The label shown below is not of actual size.) ____________________________________________________________ WARRANTY This Limited Warranty applies in the United States to products distributed under the MAXXUS brand name.
