Instructions / Assembly

desired settings, press the START/WORK button. If you don’t press the button for 5 seconds, the control panel

will stop flashing and the set-up values will be memorized. The WORK and HEAT lights will now be on and the

emitters will now be generating heat. You will need to pre-heat the sauna room to the set temperature before

entering. Please keep in mind that you will increase the time it takes for the sauna room to reach the set

temperature if you enter the sauna room before it has reached the set temperature.

4. During your sauna session, set-up time will count down the minutes one by one. When the time remaining is 5

minutes, the buzzer will make a warning sound for approximately 15 seconds letting you know you only have 5

minutes remaining. At this point, you can let the time run out or adjust the time by pressing the up/down arrows

under the TIME DISPLAY. If you do choose to adjust the time, the control panel will flash and the emitters will

stop generating heat. Once you set the time to the desired setting, then press the START/WORK button twice

and the control panel will stop flashing and heat will began coming from the emitters once again.

5. Heating times do vary. Generally, it will take approximately twenty to thirty minutes to preheat the sauna to 50

degrees Celsius / 122 degrees Fahrenheit. When the ambient temperature is low, heating requires additional

time. For the first few times of use, you may use 46 degrees Celsius /

115 degrees Fahrenheit as a reference starting point for a time period of about 15 minutes (this represents the

actual time you are in the sauna at the desired temperature). As you become more comfortable and familiar with

the sauna, you can increase the temperature and time period according to personal preference.

6. When the temperature is at the set-up value, the digital control will maintain the set temperature.

The WORK light will remain on and the HEAT light will turn off. The emitters will stop generating heat. Once

the inside temperature drops approximately 4 degrees, the HEAT light will turn back on and heat will again be

generated by the emitters. With the digital control, the inside temperature will always remain around the

set-up value.

7. Reading lamps and/or roof lamps and/or color therapy lamps are operated by pressing the respective buttons

located towards the center of the control panel. These lamps are offered on some models and are not

available on all models.