Instructions / Assembly

Assembly Instructions

A. Choose a good location to install the sauna

1. The location must be dry, leveled, and away from any source of water.

2. The heater must be installed by a certified electrician.

3. Three adults are required for installation.

4. Sauna Panels: FLOOR PANEL – LEFT SIDE WALL PANEL – REAR WALL

PANEL – RIGHT SIDE WALL PANEL – FRONT WALL PANEL – INTERIOR

ROOF PANEL – BENCHES/BENCH SUPPORT PANEL/BACKREST/STEP –

EXTERIOR ROOF PANEL

5. Tools Required: Battery Operated Screwdriver or Hand-Held Philips

Screwdriver, Rubber Mallet, and (2) Ladders.

B. Installing the FLOOR PANEL and REAR WALL PANEL

1. Place the FLOOR PANEL in the chosen location for the sauna room.

Please note that the wood pattern on the floor runs front-to-back. You will

need to have enough space to navigate around the sauna room while

assembling. Next, place the REAR WALL PANEL up and onto the FLOOR

PANEL. One adult will need to hold the REAR WALL PANEL in place.

Please note that if the BACKREST is not already installed, it will be

installed in a later step. (see Figure 1)

2/3 of the WALL

PANELS will sit on the

FLOOR PANEL

Figure 1