MAXXSONICS THE BASS CREATOR DIGITAL BASS RESTORATION MBC1
MBC1 BASS CREATOR DIGITAL BASS RESTORATION Congratulations on purchasing the MBC1! You are now the proud owner of the finest and most accurate bass enhancing and restoration system available. INDEX PAGE Specifications and Feature Descriptions...........................................................................................................1 MBC1 Drawing and Functions.........................................................................................................................
MBC1 SPECIFICATIONS Maximum Input Level.............................................................................................15V rms Maximum Output Level......................................................................................13.5V peak Frequency Response......................................................................10Hz - 100KHz; +/-1dB Total Harmonic Distortion.........................................................................................0.003% Signal to Noise Ratio...
2 R INPUT L BALANCED OUTPUT L R 7V 9V .2V 2.5V R REMOTE DIGITAL BASS RESTORATION MBC1 GROUND ISOLATION REM / 12V / GND GROUND 200-Ohms ISOLATED BASS CREATOR CENTER FREQUENCY UNBALANCED RCA INPUT WIDE NARROW FREQUENCY RANGE THE OUTPUT LEVEL CONTROL 4.
CENTER FREQUENCY: This knob allows you to select the frequency you want the MBC1 bass restoration circuit to maxximize. FREQUENCY RANGE: This knob allows for you to adjust the range of frequencies from your center point. All the way to the left will include the maxximum frequencies to maxximize, while all the way to the right will enhance only a limited amount f frequencies near your CENTER FREQUENCY.
MBC1 WIRING DIAGRAM Source Unit OUTPUT LEVEL CONTROL 4.5V CENTER FREQUENCY FREQUENCY RANGE 2.5V 7V 9V .
TROUBLESHOOTING A SYSTEM The key to finding the problem in a troubled sound system is to isolate parts of that system in a logical fashion to track down the fault. The diagnostic system will not shut down the MBC1 or the amplifier(s), although the amplifier(s) own protection circuitry may shut the amplifier(s) down should a fault status occur. At which time you will need to consult the owners manual for that particular amplifier. Low output power 1 - Check that level controls have been set up properly.
Maxxsonics Limited Warranty As the manufacturer of Maxxsonics, MB Quart, Hifonics, Crunch and Autotek car audio products, Maxxsonics USA Inc. Warrants to the original consumer purchaser the amplifier to be free from defects in material and workmanship for one (1) Year from date of purchase. All other parts and accessories of the system are warrantied to be free from defects in material and workmanship for one (1) year from date of purchase.
PART # F811
