Installation Guide

1. Make sure the POWER IS TURNED OFF at the source to the location in which you are installing the product.
2. Determine the location for installation and cut a ceiling hole with an approximate "A" diameter as stated in the
commercial down light housing compatibility table.
3. Attach the carabiner safety clip to a secure place inside the ceiling (fig. 1).
4. Insert lamp conduit into the J-box and wire to power source (black to hot, white to neutral, green to ground) (fig.
2). If a dimmer is used connect the purple wire to the "+" (typically purple wire) and the gray wire to the
"-" (typically gray wire). Reattach J-box cover when done.
5. Adjust the lamp power to desired lumen output and CCT by sliding the selector switches on top of fixture housing
(fig. 3).
6. Squeeze the two housing clips so they are in an upright position and insert lamp into the ceiling (fig. 4).
7. Once lamp is inside the ceiling, release the housing clips and continue pushing lamp into ceiling until securely
fixed and flush (fig. 5).
NEW CONSTRUCTION INSTALLATION
Five Year Warranty:
Maxxima extends a 5 year limited warranty to the original purchase that the products listed are free from defects in material
and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails
because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable
and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee
and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
[e-mail] 866-MAXXIMA (629-9462) www.maxximastyle.com
125 Cabot Court Hauppauge, NY 11788
fig. 1
Fig. 2
fig. 3
fig. 4
fig. 5
• Leviton: IP710-FZ
• Lutron: DVSTV-WH
• Maxxima: MEW-DM600LV, MEW-DM650LV
APPROVED DIMMERS
WARRANTY