Full Product Manual

Model 70225 Page 4
Assembling the Trailer Dolly
1. Refer to illustration above and to the As-
sembly Diagram at end of this manual.
2. Set out the Support Frame (3). Attach
Hitch Ball (10) to top of Support Frame, us-
ing Nut (11) and Spring Washer (12).
center bracket of Support Frame. First con-
nect Handle Bracket (6) to center bracket
of Support Frame (3) using Bolts (22), Flat
Washers (18), and Nuts (20)
4. Next, connect front part of Link Bar (4)
to horizontal crossbrace of Support Frame
(3) using Bolt (13), Flat Washer (14), and
Nut (16).
5. Connect back part of Link Bar (4) to
Handle Bracket (6) using one Bolt (17), one
Bolt (21), Flat Washers (18) and Nuts (20).
Only hand tighten Nuts as Nuts will need
to be removed when assembling Handle (7)
and Triangle Stand (5).
6. Now position Handle (7) inside Handle
Bracket (6). Position Triangle Stand (5)
underneath Handle (7) and tigthen both in
place using the above hardware mentioned
in #5 above, and use one more Bolt (21), Flat
Washer (18) and Nut (20) to attach another
end of Triangle Stand (5) to Handle (7).
7. Slide on Wheel (1) at each end of axle;
SPECIFICATIONS
Maximum Load Capacity 600 Lbs.
Hitch Ball 1-7/8” Diameter
Hitch Ball Shank Diam-
eter
3/4”
Tires 12” x 4” Knobby Tread
Finish Powder Coated
Support
Frame (3)
Hitch Ball (10)
Handle (7)
Handle
Bracket (6)
Triangle Stand (5)
Link Bar
(4)
add Washer (2) to each end of axle and se-
cure Wheels in place by inserting Split Pins
(9) through the axle.
7. With assembly complete, tighten all hard-
ware and roll the Trailer Dolly to make sure it
functions properly.
Using the Trailer Dolly
1. Make sure loaded trailer’s load capac-
ity does not exceed 600 Lbs.
2. Chock tires of the loaded trailer to be
transported. Loaded trailer must be on a
3. Move the Trailer Dolly into place and
connect the trailer tongue to the Trailer Dolly
Hitch Ball.
Always keep arms, feet
and legs away from under the trailer when
hitching, unhitching or moving the trailer.
4. Once the Trailer Dolly is securely con-
nected to the trailer, remove trailer’s wheel
chocks.
5. With hands on the Handle (7), slowly roll
and maneuver the trailer to the desired loca-
tion.
6. Trailer’s wheels must be chocked again
once the trailer is in the new location. Never
leave the Trailer Dolly unattended while it is
under load.
7. Unhitch the Trailer Dolly and move it
away from the trailer.
Support Frame
Center Bracket
WARNING