Use and Care Manual

1. Test GFCI (Ground Fault Circuit Interrupter)
plug BEFORE EACH USE.
• Plug GFCI into power outlet. Press RESET
button (A). Indicator (B) should turn red.
• Press TEST button (C). Indicator (B) should
turn off. GFCI plug is tripped.
• Press RESET button (A) again for use.
• DO NOT USE FAN IF ABOVE TEST FAILS.
Call customer service department for assistance.
ASSEMBLY INSTRUCTIONS
HARDWARE USED
Attach the fan body (A) to the stand pole (B).
To adjust air flow up and down,
tilt the fan to the desired angle.
Tighten the plastic nut tightener (AA)
on both tilt nuts to secure fan head.
Align holes on the pole of fan body (A) and
attach 2 screws (BB) and 2 spring washers (CC),
then tighten the screws (BB) firmly.
6
2x
x 2
x 2
AA
renethgiTtuNcitsalP
BB
CC
Screw
Spring Washer
2.
OPERATING INSTRUCTIONS
C
B
A
RESET
TEST
2
AA
CC
BB
1