Installation Guide

13
CONTROL PANEL
(behind front cover)
Descripons of LEDs and buons:
1. Red LED: Ice Full indicator light.
When this LED is lit, the ice storage bin is full of ice or there is
something between the two arms of the ice-full sensor in the ice
storage bin. The unit will stop working. When ice cubes are taken
out of the ice storage bin, clearing the sensor, the red LED will keep
ashing for 3 minutes. Then the unit will restart and return to the ice
making mode.
2. Green LED: Ice Making indicator light.
When this LED is lit, the unit is working in the Ice Making mode
controlled by a temperature probe on the evaporator. When the green
LED is ashing, the unit is working in the Ice Making mode controlled by
a xed mer.
3. Yellow LED: Ice Harvest indicator light.
When this LED is lit, the unit is working in the Ice Harvest mode
controlled by a temperature probe on the evaporator. When the
yellow LED is ashing, the unit is working in the Ice Harvest mode
controlled by a xed mer.
4. Clean buon: When this buon is pressed, the unit enters the Cleaning mode. The green and yellow LEDs
ash together. To stop the Cleaning mode, just press the buon again.
5. Mode buon: Mainly for service. When this buon is pressed, unit can change from Ice Making mode to Ice
Harvest mode, or from Ice Harvest mode to Ice Making mode. You can judge the mode from the status of the
green and yellow LEDs.
6. Adjust buon: Mainly for service. When this is pressed over 3 seconds, the unit will enter the Ice Size
Adjustment mode. The mode can be judged from the status of the green LED.
Ice Size Adjustment Guide:
1.) Press and hold the “Adjust” buon for at least 3 seconds. The unit will enter the Ice Size
Adjustment mode. The “ICE Making” LED (green) will be blinking connuously during the ice size
adjustment. Release the buon when the LED blinks connuously to adjust the ice size.
2.) While in the Ice Size Adjustment mode, press the “Clean” buon or the “Mode” buon for the
desired ice size.
Smaller ice seng:
By pressing the “Clean” buon, you can decrease the size of the ice cubes. The “ICE FULL” LED (red)
will ash as you lower the ice size and will nally be blinking at the seng of smallest ice size.
Larger ice seng:
By pressing the “Mode” buon, you can increase the size of the ice cubes. The “ICE HARVEST” LED
(yellow) will ash as the larger size is set and will blink when the seng of largest ice size has been
reached.
Aer 10 seconds without any operaon, the unit will automacally memorize the current state and
return to the previous mode.
NOTE:
• During the ice size adjustment, the “ICE FULL”, “ICE MAKING” and “ICE HARVEST” LEDS
blinking all at once indicate that the unit is in the regular (middle) seng of the ice size.
• When the machine is in the cleaning stage or ice full stage, the ice size is not available
for adjusng.
NOTE: Avoid leng water contact the control box.
Red LED
Green LED
Yellow LED
Clean
Adjust
Mode
Ice-full
Ice-making
Ice-harvest